GL1200 GOLDWINGS

Full Version: Oil Seal
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I am looking for an oil seal (25X54X12) for the rear cover which has been discontinued by Honda. The part number is 91201-ML8-003. Is there an aftermarket replacement for it?

Thanks Andy
Thanks Ken!
It is the wrong seal
Aftermarket seal manufacturers do make a 25x54x8. It isn't as deep, but inside and outside diameters are the same. Since the original is no longer available, this is your next best choice. I haven't seen many of these leak. Are you sure this is what you're looking for?
I had the engine out to replace the stator (no I will not install a poor boy kit). I wanted to replace to that seal and what ever else I could while I had access to it.
What state was the main fuse when you checked it?

No doubt you will replace the stator again
There is nothing wrong with the main fuse. The bike is 32 years old with almost 45,000 miles on it. This is the first time the stator was replaced.