Guest
06-29-2009, 12:00 PM
Has anyone used this tool to sync the GL1200 carbs? If so where does it connect , vacumn hoses. .I know the carbs are sync off off #4.I believe that is left rear.
Thanks
Thanks
06-29-2009, 12:00 PM
06-29-2009, 01:47 PM
Yes, a good piece of equipment.
Connects with adapters to the 4 screws at the lower end of the intake tubes.
Connects with adapters to the 4 screws at the lower end of the intake tubes.
Guest
07-01-2009, 04:09 PM
The adapters I have don't fit the openings. What did you do?
Thanks
Barry
Thanks
Barry
07-01-2009, 05:34 PM
If you bought the carbtunes new they had a metric set and an imperial set of adapters.
You could purchase 4 metric allen bolts that fit the thread in the intakes and drill a fine hole. the hoses should just fit over the head of the allen bolts.
You also could contact carbtunes at <!-- m --><a class="postlink" href="http://www.carbtune.com/">http://www.carbtune.com/</a><!-- m --> on the first page where it says:
The dog ate my ....
Get your spares here
A set of adapters 5 UK pounds I do believe,
You could purchase 4 metric allen bolts that fit the thread in the intakes and drill a fine hole. the hoses should just fit over the head of the allen bolts.
You also could contact carbtunes at <!-- m --><a class="postlink" href="http://www.carbtune.com/">http://www.carbtune.com/</a><!-- m --> on the first page where it says:
The dog ate my ....
Get your spares here
A set of adapters 5 UK pounds I do believe,
07-01-2009, 07:34 PM
I have it and it comes with the right adapters to do the job....wow!!! what a great tool!!!