GL1200 GOLDWINGS

Full Version: gl200 clutch won't disengage
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Guest

Bike has 118k.Clutch was fine until about a week ago.Switch bad on clutch level? Where do I look ?
First, check the bushing in the clutch lever to see if it is worn oblong, if yes then order a replacement. Next fully flush and bleed the clutch hydraulic system and make sure you get all the air out by finally bleeding at the banjo bolt on the master cylinder (cover the bike so you don't get brake fluid on it.) If you do a proper bleed, slave cylinder first, you should have a solid clutch lever feel, if not the slave or master cylinder needs rebuilding.