Thread Rating:
  • 3 Vote(s) - 2.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5
gl200 clutch won't disengage
Bike has 118k.Clutch was fine until about a week ago.Switch bad on clutch level? Where do I look ?
Reply
#1 07-10-2010, 08:54 PM,
First, check the bushing in the clutch lever to see if it is worn oblong, if yes then order a replacement. Next fully flush and bleed the clutch hydraulic system and make sure you get all the air out by finally bleeding at the banjo bolt on the master cylinder (cover the bike so you don't get brake fluid on it.) If you do a proper bleed, slave cylinder first, you should have a solid clutch lever feel, if not the slave or master cylinder needs rebuilding.
Ed (Vic) Belanger - 1954-2015
Founder of gl1200goldwings.com

Reply
#2 07-11-2010, 02:50 AM,


Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html