Thread Rating:
  • 4 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can you turn motorcycle rotors?
I am wondering if you can have motorocycle rotors turned or if you just replace them when they are worn. I know I can replace the pads, but I'd rather have the rotors turned than buy a new pair. They get expensive fast.

Thanks!
Rob
'85 Interstate with the poorboy kit!
Reply
#1 01-24-2007, 06:53 AM,
Yes, they can be turned but not like disk brake rotors from cars.

What's needed to true the rotors on your Wing is a lathe with stones that can grind a non directional finish on both sides of the rotor at the same time. Only a minimal amount of material should be taken off. If you read the rotor the minimum thickness will be marked on the rotor.
Ed (Vic) Belanger - 1954-2015
Founder of gl1200goldwings.com

Reply
#2 01-25-2007, 03:13 PM,
It might be best to take them to a machine shop that has a blanchard grinder.
Instead of trying to turn the rotors.
You are only talking about taking off .1-.2 mm per side at the most, which works out to .004-.008 thousands of an inch.
You will end up with a nice cross hatch on the rotors if they are ground.
Reply
#3 01-26-2007, 02:12 AM,


Possibly Related Threads…
Thread Author Replies Views Last Post
  new brake rotors? Tropicalsuns 10 622 08-27-2012, 04:00 PM
Last Post: SIR tricky
  Question about brake rotors garyft 6 417 06-19-2009, 04:27 AM
Last Post: thorndaleaspy

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html