cb stay on 9 channel

[jerome]

Hello i'm sorry for my english but i'm French and my english isn't very good. I 've a problem with my cb. It stay on 9 channel even i push on the swich of emergencie. I think the problem became to the swich on the electronic cart but i'm not sure. In plus i dont have the electronic draw. Someone can help me please?
thank you
JÃrôme

[neoracer]

if the button is stuck it may not be allowing you to change out of the channel 9 emergency function,the radio can be taken apart and unstuck

[SIR tricky]

Probably the switch cover is sticking.

spray a little electrical contact cleaner around the switch cover.

the part that you actually see is not the actual switch but a cover that goes over the switch. The shape of a square top hat.

[jerome]

the cover swich it's out because there are not connection bettwen the cover and the electronic card swich. I trie to put electrical contact clearner on the electronic card swich but nothing change. It always stay on emergencie channel. When i test the swich with an ohmeter the 3 pin on the right are always connect and on the left side, the 2 pin on the low are always connect and the pin on the top is only connect when the swich it's on emergency position. Is it normal?
Thank you
JÃrôme

[SIR tricky]

Sorry I can't give you any measurements, if you are capable here is the schematic if it is of any value.

You could email the guys at <!-- m --><a class="postlink" href="http://www.sierra-mc.com/">http://www.sierra-mc.com/</a><!-- m --> they are the people who can repair the Honda radios.

[jerome]

ok thank you for all informations. I'll contact sierra.
Bye
JÃrôme

[Brodaty Mis]

For me it is only button mechanical problem.
My Friend has same problem. I take with knife the button to "off" position and spray litle oil.
Maybe this?...
BM

[jerome]

Before i think the same thing but i had do all your description and the problem stay. Tricky, have you the draws for the other electronic card of the cb please?
If i 'll all draws, i think i'll could repair my cb.
Thank you
JÃrôme

[jerome]

Hello thank you for your help (the draw was precious for me ). I had foud the problem. It was a bad soldering on the power card. I had remake it and now it's ok.
Bye
JÃrôme

[SIR tricky]

These are all the schematics I have of the CB

[jerome]

Hello,
thank you very very much. I think i'll can help a lot of French wingner.
Best regards
JÃrôme